Materials
- Student tray containing the following:
- 1-250mL beaker (with measurement lines printed on side)
- 1-50mL beaker (with measurement lines printed on side)
- Thermometer
- 1-50 mL graduated cylinder
- Weight boat
- Paper clip
- Pipet
- DI water bottle
- Supply beaker with disposable items: pipettes, scoopula, small weigh boat, parafilm.
- Container of glassware soap and a brush in a beaker labeled “Waste.”
- Balance
Drawers:
Additional materials that will be used throughout the semester can be found in your student drawer to include:
- green pipet pump
- 2 rolls of labeling tape
- test tube holder
- 1 striker
- 1 sharpie
- 1 rubber “hot hand” mitt (every other drawer)
- 1 glassware tongs
- 1 beaker tongs
- 1 ruler
- 1 long handled deflagrating spoon
- 1 goggles
- Components for ring/support stand
- Mesh/gauze square
- Clay Triangle
- Ring
- Test tube Clamp with vinyl coating
- Titration/thermometer clamp with fingers or test tube clamp w/vinyl coating(either one in every other drawer)
- Mat glued to drawer
Cabinet:
- Test tube rack
- Hotplate
- Bunsen burner with gas line
Benchtop:
- Ring support stand to be shared with group of 4 with titration clamp
Safety and Other Information
- Wear safety goggles at any time any group is performing the experiment.
- Inspect all equipment for damage. Broken or chipped glassware should be reported and placed into glass container.
- The balance should be in the lock position during transport. When ready to use unlock the balance by turning it over and finding the switch. Use the balance in the unlocked position when weighing.
- At the end of the lab switch it back to the lock position and return to the cart.
- Waste water for today’s lab can be disposed of down the drain at your station.
- Return all trays with in order with clean, dry glassware and items and place on cart.
- Please, please return all # materials to the proper # drawers and # trays.