http://www.slideshare.net/CandelaContent/homeostasis-51118996

Download a PDF of the lab to print.

Homeostasis describes the dynamic balance of the body’s internal environment and the effort to maintain a constant, stable inside. There are many body components that contribute to homeostasis. This lab activity will focus on the liver and the kidneys.

Part I: Liver

The liver is an organ within the digestive system and is responsible for maintaining sugar levels in the blood as part of homeostasis. After a large meal, the liver converts extra glucose into glycogen, a polysaccharide that stores glucose. A hormone called insulin is produced by the pancreas stimulates glycogen production. When levels of glucose in the blood drop, the liver breaks down glycogen back into glucose for the blood to circulate throughout the body. A hormone called glucagon produced by the pancreas stimulates this process. All cells of the body require glucose for cellular respiration to make energy.

The liver receives blood from the small intestines through the hepatic portal vein. After a large meal, the hepatic vein would transport glucose rich blood from the small intestines to the liver. Blood leaves the liver and returns to the heart through the hepatic vein. We will conduct a simulation to learn more about the liver’s role in maintaining blood glucose levels in relationship to homeostasis.

The table below describes the blood serums you will test:

We will use a test called the Benedict’s test to determine the amount of glucose in each location.  The benedicts test ranges in color from blue (no glucose) to orange/red (lots of glucose). Follow the directions below.

Procedure

Glucose levels after eating:

1. Fill the large beaker ½ full with tap water. Place the beaker on top of the hot plate. Turn the hot plate on to create a hot water bath.
2. Label three test tubes A1, B1, and C1 with a wax pencil
3. Use the small plastic ruler to mark on the test tube at 1 cm and 2 cm.
4. Fill test tube A1 to the 1 cm mark with serum A1 and to the 2 cm mark with Benedict’s reagent.
5. Fill test tube B1 to the 1 cm mark with serum B1 and to the 2 cm mark with Benedict’s reagent.
6. Fill test tube C1 to the 1 cm mark with serum C1 and to the 2 cm mark with Benedict’s reagent.
7. Place all three test tubes into the hot water bath at the same time.
8. Heat the tubes for 5 minutes. Observe and record any color changes.
9. Record your results in the table below. Remember that blue indicates no glucose and red/orange indicates the most glucose. A green color signifies some glucose.

Results

Procedure

Glucose levels before eating:

1. Keep your hot water bath from the first procedure
2. Label three test tubes A2, B2, and C2 with a wax pencil
3. Use the small plastic ruler to mark on the test tube at 1 cm and 2 cm.
4. Fill test tube A2 to the 1 cm mark with serum A2 and to the 2 cm mark with Benedict’s reagent.
5. Fill test tube B2 to the 1 cm mark with serum B2 and to the 2 cm mark with Benedict’s reagent.
6. Fill test tube C2 to the 1 cm mark with serum C2 and to the 2 cm mark with Benedict’s reagent.
7. Place all three test tubes into the hot water bath at the same time.
8. Heat the tubes for 5 minutes. Observe and record any color changes.
9. Record your results in the table below. Remember that blue indicates no glucose and red/organge indicates the most glucose. A green color signifies some glucose.

Results

Once you have recorded your results, please clean up the materials. Make sure to:

• Turn off and unplug the hot water bath
• Dump the contents of the test tubes down the sink
• Wash out the test tubes and place them in the test tube rack to dry

Part II: Kidneys

The kidneys are part of the urinary system. As they produce urine to release nitrogenous wastes from the body the kidneys also maintain homeostasis through pH balance and water-salt balance in osmoregulation. These bean shaped organs are located along the dorsal wall of the abdominal cavity.

Observe the kidney models available in the lab. Locate the outer renal cortex tissue and the more internal renal medulla.  The renal pelvis is the area that collects the urine. Find the renal artery and the renal vein.

The functioning unit of the kidney is called the nephron. Part of the nephron is located in the cortex and part in the medulla. Use the picture below and the models in the lab to identify the following components of the nephron.

• Glomerulus
• Bowman’s capsule
• Proximal tubule
• Distal tubule
• Loop of Henle (descending limb and ascending limb)
• Collecting duct
• Peritubular capillaries

Urine production in the kidney involves four main steps:

1. Filtration: molecules move out of the glomerulus into Bowman’s capsule. Large molecules like proteins and blood cells are too big to be filtered and remain in the blood.
2. Reabsorption: glucose and amino acids move from the proximal tubule back into the blood stream through peritubular capillaries.
3. Secretion: Substances like histamines, H+, and ammonia get secreted into the nephron from the peritubular capillaries
4. Water reabsorption: both the Loop of Henle and the collecting duct reabsorb water to maintain the blood volume

Label the parts of the nephron on the diagram below and indicate where the different urine production steps occur.

Focus on Filtration

Blood entering the glomerulus contains cells, proteins, glucose, amino acids, salts, urea, and water. Fill in the table below indicating which molecules will leave the glomerulus and enter the Bowman’s capsule. Write yes or no for each and state why based on size (small or big).

Focus on Reabsorption

When the filtrate enters the proximal tubule it contains the following molecules: glucose, water, urea, amino acids, and salts. Water and salts are passively reabsorbed to maintain blood volume and pH as part of homeostasis.

Kidneys are also important in osmoregulation, maintaing an internal salt/water balance. The kidney can produce large amounts of dilute urine or small amounts of concentrated urine depending on the needs of the body. The pituitary glad produces antidiuretic hormone (ADH) which controls the concentration of urine output. ADH specifically acts on the collecting duct making it more or less permeable to water.

The table below has several different events that would impact osmoregulation. Fill in the chart with either “increase” or “decrease” to explain how the kidney would help maintain homeostasis.

Kidneys also play a role in pH balance.